臺灣博碩士論文加值系統

在平行耦合線帶通濾波器的設計中，本文利用輸入、輸出級耦合線長度適當的增加與重疊，在上截止頻帶產生兩個傳輸零點，以抑制濾波器的寄生二階諧波，增加截止帶的衰減率、並改善通帶的對稱性。這種重疊架構的耦合線，會讓奇模的路徑長度大於偶模的路徑長度，因為奇模的相速比偶模的相速來得大，此結構剛好可以針對奇模、偶模相速不一致的情形作補償產生零點。本論文利用這一個特點，將兩個傳輸零點放在最佳的位置，達到最好的二階諧波抑制效果。本文有數個實作電路，其模擬與量測結果相當一致。

An overlap scheme at both end stages of parallel coupled microstrip filters is investigated to improve the passband symmetry and suppress the parasitic passband at twice the center frequency. The overlap scheme extends the phase length for the odd mode so that the electric lengths of the entire filter for both odd and even modes can be identical, so that a transmission zero can be located near twice the passband frequency. Simulation results show that the required overlap length may change as the filter specification or the substrate is changed. It is found that the spurious response at twice the passband frequency can be suppressed down under —40 dB. Good agreement between measured and simulated results shows that the idea works very well.

中文摘要……………………………………… i
英文摘要……………………………………… ii
致謝…………………………………………… iii
目錄…………………………………………… iv
圖目錄………………………………………… v
表目錄………………………………………… vii
第一章 緒論…………………………………………… 1
第二章 平行耦合微帶線帶通濾波器的基本原理…… 4
2.1 平行耦合微帶線的分析…………………………… 4
2.2 平行耦合線濾波器的設計公式…………………… 10
2.3 任意鏡像阻抗平行耦合線濾波器的設計公式… 11
第三章 具二階諧波抑制平行耦合線濾波器的原理、
模擬與量測………………………………… 19
3.1 使用過度耦合結構抑制二階波……… 19
3.2 過度耦合微帶線與傳輸零點之間的關… 22
3.3 電路的規格及模擬與量測的結果……… 23
3.4 電路量測結果的比較…………………… 24
第四章 結論……………………………………… …… 47
參考文獻 ………………………………………………… 48

參考文獻：
[1]D. M. Pozar, Microwave Engineering, New York: John Wiley & Sons, Ed., 1998, chap. 8.
[2]Chi-Yang Chang, Tatsuo Itoh, A Modified Parallel-Coupled Filter Structure That Improves the Upper Stopband Rejection and Response Symmetry, IEEE Trans. MTT VOL. 39, NO. 2, FEB. 1991.
[3]Jen-Tasi Kuo, Eric Shih, Stepped Impedance Resonator Bandpass Filter with Wide Stop bandpass Filter-An Optimal Implementation, IEEE MTT-s 2002
[4]Jen-Tasi Kuo, Meshon Jiang, Suppression of Spurious Resonance For Microstrip Bandpass Filters Via Substrate, APMC
[5]Jen-Tasi Kuo, Wei-Hsiu Hsu, Wei-Ting Huang, Parallel Coupled Microstrip Filters with Suppression of Harmonic Response, IEEE Microwave Wireless Components Letter 2002
[6]Dal Ahn, Chul-Soo Kim, Min-Ho Chung, Dong-Hwan Lee, Dae-Won Lew, Heon-Jin Hong, The Design Of Parallel Coupled Line Filter With Arbitrary Image Impedance, IEEE MTT-S Digest, pp. 909-912, 1998.
[7]Alfy Riddle, High Performance Parallel Coupled Microstrip Filters, IEEE MTT-S Digest, pp. 427-430, 1988.
[8]Hoffmann, R.K., Handbook of Microwave Integrated Circuits, Artech House, Norwood, 1987.
[9]Easter, B., and Merza, K.A., Parallel-Coupled-Line Filters for Inverted-Microstrip and Suspended-Substrate MIC’s, European Microwave Conf. Digest, pp. 164-167, 1981.
[10]Kirschning, M., and Jansen, R.H., Accurate Wide-Range Design Equations for the Frequency-Dependent Characteristics of Parallel Coupled Microstrip Lines, IEEE Trans. MTT., pp. 83-90, Jan. 1984.
[11]J.P. Gilb and C.A. Balanis, Pulse distortion on multilayer coupled microstrip lines, IEEE Trans. Microwave Theory Tech., vol. 37, no. 10, pp. 1620-1628,Oct. 1989.
[12]Rajesh Mongia, Inder Bahl, Prakash Bhartia, RF and Microwave Coupled-Line Circuits, Boston: Artech House, 1999, chap. 9.
[13]George L. Matthaei, Leo Young, E. M. T. Johns, Microwave Filters, Impedance Matching Networks, and Coupling Structures, Artech House, 1980, chap. 8.
[14]S. B. Cohn, Parallel-Coupled Transmission-Line-Resonator Filter, IEE Trans. Microwave Theorey Tech., vol. MTT-6, pp.223-231, Apr. 1958.
[15]Zeland Software Inc., IE3D simulator, Jan. 1997.