臺灣博碩士論文加值系統

本論文設計主題為低電壓電流供给電路，且具備寬擺幅(High swing)、高輸出阻抗、恆定電流等特性。本設計其電流鏡，除可在低電壓運作外，對於溫度係數也有相當程度補償，以及操作穩定。
本文使用工作站的Hspice模擬軟體，此外，電路設計上，所採用的元件為互補式金氧半場效電晶體(CMOS) 。即使用國家晶片中心(CIC)所提供之台積電(TSMC) 0.35μm標準製程元件，進行研究、設計與比較。

The present paper mainly design low voltage current supply circuit, whose properties are high swing, high output impedances, constant output current. In the research, the designed current supply has the properties of low voltage work, proper temperature coefficient compensate, and stable operation.
Mainly, the software HSPICE on workstation is used for the circuit design. The devises in circuits are offered by National Chip Implementation Center. Under the 0.35μm regular processes of Taiwan Semiconductor Manufacture Cooperator, this paper is going to investigate, design, and compare.

目錄
摘要 II
Abstract III
目錄 IV
圖目錄 V
圖目錄 VI
表目錄 VIII
第一章　緒論 1
1.1前言 1
1.2研究動機 1
1.3論文架構 2
第二章 電流鏡介紹與分析 3
2.1 電流鏡原理介紹 3
2.2 基本電流鏡(Basic Current Mirror) 3
2.3 疊接電流鏡 (Cascode Current Mirror) 6
2.4 與供應電源無關之電流源電路 9
第三章 低電壓電流供给電路設計 12
3.1低電壓電流鏡簡介 12
3.2低電壓電路設計 13
第四章 電路模擬結果與討論 16
4.1 基本IC設計理論及使用工具 16
4.2 本論文所研究的電路及架構 18
4.3 研究結果 19
第五章 結論 38
5.1結論 38
5.2 未來研究方向 38
參考文獻 40
附錄 42

[1] Hspice 積體電路設計分析與模擬導論(第二版)”,東華Behzad Razavi,“Design of analog CMOS integrated circuits”,MCGRAW-HILL, 2001.
[2] David A. Johns, Ken Martin,“Analog integrated circuit design”,John Wiley & Sons, 1997.
[3] R. Jacob Baker, “CMOS circuit design, layout, and simulation(second edition)”,John Wiley & Sons, 2007.
[4] Paul R. Gray, Paul J. Hurst, Stephen H. Lewis, Robert G. Meyer,“Analysis and design of analog integrated circuits(fourth edition)” John Wiley & Sons, 2001.
[5] Kenneth R. Laker, Willy M. C. Sansen,“Design of analog integrated circuits and systems”, MCGRAW-HILL, 1994.
[6] 林振華, “CMOS 類比電路”, 全華書局, 民國八十九年。
[7] 蕭培墉, 吳孟賢,“書局, 民國九十六年。
[8] 盧明智, 黃敏祥,“OP Amp應用+實驗模擬(含filter、A/D、D/A、VCO、V/F、F/V)”, 全華書局, 民國九十年。
[9] Phillip E. Allen, Douglas R. Holberg, “CMOS Analog Circuit Design”,New York : oxford, 2002.
[10] Z. Butkovic and A. Szabo, "Analysis of the CMOS differential amplifier with active load and single-ended output", IEEE in Electrotechnical Conference, pp. 417-420, 2004.
[11] M. M. Ahmadi, "A new modeling and optimization of gain-boosted cascode amplifier for high-speed and low-voltage applications", IEEE Transactions on Circuits and Systems II: Express Briefs, vol.53, pp. 169-173, 2006.
[12] 黃俊達, 鄔文杰, 陳森元,“電子學(第二版)”,全威圖書, 民國99年。
[13] M. Emadi, B. Foruzandeh, F. Farbiz, and E. Fathi, "Gain boosted amplifier design for low power-high speed applications", The 2nd Annual IEEE Northeast Workshop on Circuits and Systems, pp. 233-235, 2004.
[14] R. Musa, Y. Yusoff, Yew Tan Kong, and M. R. Ahmad, "Design of Single-Stage Folded-Cascode Gain Boost Amplifier for 100mW 10-bit 50MS/s Pipelined Analog-to-Digital Converter", IEEE International Conference on Semiconductor Electronics, ICSE '06., pp. 800-804, 2006.
[15] Anthony Scanlan, "Fast Settling Gain Boosted Folded Cascode Amplifiers", Irish Signals and Systems Conference, IET, pp. 335-338, 2006.
[16] F. Corsi and C. Marzocca, "An approach to the analysis of the CMOS differential stage with active load and single-ended output", IEEE Transactions on Education, vol. 46, pp. 325-328, 2003.
[17] B. Lipka and U. Kleine, "Design of a Cascoded Operational Amplifier with High Gain", IEEE International Conference on Mixed Design of Integrated Circuits and Systems, MIXDES '07., pp. 260-261, 2007.
[18] 林根右，電流源對差動放大器影響之分析，建國科技大學電機工程研究所，碩士論文，民國九十八年。
[19] 吳傑，邱關源。 CMOS電流鏡及應用[J]。 湖南大學學報1996.
[20] 李金平。 模擬積體電路基礎[M]。 北京：清華大學出版社， 2003.
[21] 畢查德•拉紮維。 模擬CMOS積體電路設計[M]。 西安：西安交通大學出版社， 2004.
[22] 李偉華。 VLSI設計基礎[M]。 北京：電子工業出版社2002.