臺灣博碩士論文加值系統

本論文中提出一應用於無線通訊系統(WiMAX)的雙工器與三工器，主要在改善傳統雙工器及三工器的連接方式。本次設計的雙工器結合了兩個帶通濾波器，分別為四分之一波長及二分之一波長共振器的帶通濾波器，因此旁生通帶可以被壓抑，不會影響高頻的濾波器，使隔離度可以提升。而在連結兩個濾波器時以共用耦合線饋入的方式，取代傳統雙工器用T接面(T-junction)連接濾波器，使得雙工器在輸入端匹配時，電路面積可以更進一步縮小，完成一個隔離度優於30 dB的雙工器。在三工器的部分，考慮一條微帶線在單一平面上最多只能與兩條微帶線耦合，所以我們將其中一個二分之一波長帶通濾波器用槽孔耦合的方式實現，利用將接地面開一個槽孔的方式，使訊號可以經由槽孔耦合到下層的饋入線，讓上層的傳輸線，除了耦合到相鄰的耦合線外，也可以經槽孔向下耦合到下層電路，完成連結的匹配，實現一隔離度優於20 dB的雙層板三工器。電路製作皆以FR-4 的板材完成，介電常數為1.6、介質損耗為0.02。從模擬與實作結果比較，皆具有很好的一致性。

In the thesis, diplexers and triplexers for WiMAX applications are proposed. The proposed diplexer is mainly composed of a 1/2 ? and a 1/4 ? parallel-coupled-resonator bandpass filters. By using 1/4 ? parallel-coupled-resonator filter, the spurious passband will appear at 3f0. Thus, the isolation between two channels can be enhanced. In many conventional diplexer designs, T-junction is often used to connect both filters. This strategy could lead to the increase of the circuit area. Therefore, instead of the T-junction, common coupled lines are used to connect these two filters. By using the proposed matching network, a compact diplexer of high isolation (>30 dB) is thus obtained.
In the triplexer dsign, the third filter is added to the diplexer mentioned above. The signal is coupled to the third filter from the top layer to the bottom layer through the slot aperture on the ground. Then, we implemented input matching network of the triplexer without increasing extra area. The measured isolations of triplexer among channels are all better than 20 dB. All circuits are fabricated y using FR-4 substrate. The relative permittivity and loss tangent of the substrate are 4.4 and 0.02, respectively. The measured results are in agreement with the simulated results.

中文摘要 i
英文摘要 ii
目錄 iv
第一章 緒論 1
1-1研究動機 1
1-2文獻回顧 2
1-3章節介紹 4
第二章 耦合線帶通濾波器 5
2-1 簡介 5
2-2 二分之一波長共振耦合線濾波器 5
2-2-1 電路架構 5
2-2-2 濾波器設計 7
2-3 四分之一波長共振耦合線濾波器 11
2-3-1 電路架構 11
2-3-2 四分之一波長濾波器設計 13
2-4 總結 17
第三章 雙工器之設計與實作 18
3-1 簡介 18
3-2雙工器分析與設計 18
3-2-1隔離度 19
3-2-2雙工器設計 20
3-3雙工器實作與量測 30
3-4 總結 32
第四章 三工器之設計與實作 33
4-1 簡介 33
4-2 槽孔耦合帶通濾波器 34
4-2-1 槽孔耦合結構分析 34
4-2-2槽孔耦合帶通濾波器設計 37
4-3三工器分析與設計 41
4-3-1 抑制旁生通帶 42
4-3-2 三工器設計 44
4-4三工器電路實作與量測 57
4-5 總結 60
第五章 結論 61
參考文獻 62

[1]D. M. Pozar, Microwave Engineering, 2nd ed. New Work: Wiley, 1998, ch. 8.
[2]H. W. Yao, A. E. Abdelmonem, J. F. Liang, X. P. Liang, K. A. Zaki, and A. Martin, “Wide-band Waveguide and ridge waveguide T-junctions for diplexer applications,” IEEE Trans. Microw. Theory Tech., vol. 41, no. 12, pp. 2166-2173, Dec. 1993
[3]T, Ohno, K, Wada, and O. Hashimoto, “Design methodologies of planar duplexers and triplexers by manipulating attenuation poles” IEEE Trans. Microw. Theory Tech., vol. 53, no. 6, pp. 2088 – 2095, June 2005.
[4]C.-W. Tang and S.-F. You; “Design Methodologies of LTCC Bandpass Filters, Diplexer, and With Transmission Zero, ” IEEE Trans. Microw. Theory Tech., vol. 54, no. 2, pp. 717 – 723, Feb 2006.
[5]D. Orlenko, K. Markov, S. Royak, A. Gordiyenko, O. Chernyakov, T. Kerssenbrock, G. Sevskiy, and P. Heide, “Novel high-rejection LTCC diplexers for dual-band WLAN applications, ” in IEEE MTT-S Int. Microwave Symp. Dig., June 2005, pp. 727-730.
[6]A. Yatsenko, D. Orlenko, S. Sakhnenko, G. Sevskiy, and P. Heide , “A Small-Size High-Rejection LTCC Diplexer for WLAN Applications Based on a New Dual-Band Bandpass Filter., ” in IEEE MTT-S Int. Microwave Symp., June 2007, pp. 2113 – 2116.
[7]D. Kim, D. H. Kim, J. I. Ryu, and J. C. Kim, “Highly integrated triplexers for WiMAX applications,” in IEEE MTT-S Int. Microwave Symp. Dig., June 2008, pp. 1091 – 1094.
[8]D. Kim, D. H. Kim, J. I. Ryu, C. D. Park, C. S. Kim, I. S. Song, and J. C. Kim, “A Compact WiMAX Diplexer Module with LTCC and FBAR Technologies” in Proc. 39th Eur. Microw. Conf., Rome, Italy, Oct. 2009, pp. 567-570.
[9]G. A. Lee, M. Megahed, and F. D. Flaviis, “Design of multilayer spiral inductor resonator filter and diplexer for system-in-a-package,” in IEEE MTT-S Int. Microwave Symp., June 2003, pp. 527 – 530.
[10]C. M. Tsai, S. Y. Lee, C. C. Chuang, and C. C. Tsai, “A folded coupled-line structure and its application to filter and diplexer design,” in IEEE MTT-S Int. Microwave Symp. Dig., June 2002, pp. 1927-1930.
[11]A. F. Sheta, J. P. Coupez, G. Tanne, S. Toutain, and J. P. Blot, “Miniature microstrip stepped impedance resonator bandpass filters and diplexer for mobile communications,” in IEEE MTT-S Int. Microwave Symp. Dig., June 1996, pp. 607-610.
[12]S. S. Oh, and Y. S. Kim, “A compact duplexer for IMT-2000 handsets using microstrip slow-wave open-loop resonators with high-impedance meander lines,” in Radio Wireless Conf., Aug. 2001, pp. 177-180
[13]B. Strassner and K. Chang, “Wide-band low-loss high-isolation microstrip periodic-stub diplexer for multiple-frequency applications,” IEEE Trans. Microw. Theory Tech., vol. 49, no. 10, pp. 1818-1820, Oct. 2001.
[14]S. Srisathit, S. Patisang, R. Phromloungsri, S. Bunnjaweht, S. Kosulvit, and M. Chongcheawchamnan, “High isolation and compact size microstrip hairpin diplexer,” IEEE Microw. Wireless Compon. Lett., vol. 15, no.2, pp. 101-103, Feb.2005.
[15]E. Goron, J.-P. Coupez, C. Person, Y. Toutain, H. Lattard, and F. Perrot, “Accessing to UMTS filtering specifications using new microstrip miniaturized loop-filters,” in IEEE MTT-S Int. Microw. Symp. Dig., Jun. 2003, pp. 1599–1602.
[16]Jessada Kongpang, “A Compact Diplexer Using Square Open Loop with Stepped Impedance Resonators,“ in Asia-Pacific Microwave Conf., 2008, pp. 91-94.
[17]S. Hong, and K. Chang, “Stun-tuned microstrip bandpass filters for millimeter-wave diplexer design,” IEEE Microw. Wireless Compon. Lett., vol. 15, no.9, pp. 582-584, Sep. 2005.
[18]C.-F. Chen, T.-Y. Huang, C.-P. Chou, and R.-B. Wu, “Microstrip diplexer design with common resonator section for compact size but high isolation,“ IEEE Trans. Microw. Theory Tech., vol. 54, no. 5, pp. 1945 – 1952, May 2006.
[19]M.-H. Weng, C.-Y. Hung, and Y.-K. Su, “A hairpin line diplexer for direct sequence ultra-wideband wireless communications,“ IEEE Microw. Wireless Compon. Lett., vol. 17, no. 7, pp. 519 – 521, July 2007.
[20]P. -H. Deng, C.-H. Wang, and C. H. Chen “A Compact Microstrip Diplexers Based on a Dual-Passband Filter,“ in Asia-Pacific Microwave Conf., 2006, pp. 1-4.
[21]G. L. Matthaei and E. G. Cristal, “Multiplexer channel-separating units using interdigital and parallel- coupled filters,” IEEE Trans. Microw. Theory Tech., vol.13, pp.328-334, May 1965.
[22]C.-F. Chen, T.-Y. Huang, T.-M. Shen, and R.-B. Wu, “A Miniaturized Microstrip Common Resonator Triplexer without Extra Matching Network,” in Proc. Asia-Pacific Microwave Conference., 2006, pp. 1439 – 1422.
[23]H. W. Wu, K. Shu, M. H. Weng “Design of A Compact Microstrip Triplexer for Multiband Applications,“ In Proc. Eur. Microwave Conf, 2007, pp. 834 – 837.
[24]Zewani, M. Hunter, I.C. “Design of Ring-Manifold Microwave Multiplexers,“ in IEEE MTT-S Int. Microwave Symp. Dig., San Francisco, CA, pp. 689 – 692, June 2006.
[25]M-I. Lay and S-K Jeng, “A microstrip three-port and four-channel multiplexer for WLAN and UWB coexistence,”.IEEE Trans. Microw. Theory Tech., vol. 53, no 10, pp.3244-3250, October 2005.
[26]P.-H. Deng, N.-I. Lai, S.-K. Jeng, and C. H. Chen, “Design of Matching Circuits for Microstrip Triplexers Based on Stepped-Impedance Resonators,” IEEE Trans. Microwave Theory Tech., vol. 54, pp. 4185-4192, Dec. 2006.
[27]George L. Matthaei, “Direct-coupled, band-pass filters with ?????resonators,” IRE International Convention Record, vol. 6, Part 1, pp. 98-111, Mar 1958.
[28]T. Tanaka, K. Tsunoda, and M. Aikawa,“Slot-coupled directional couplers between double-sided substrate microstrip lines and their applications,＂IEEE Trans. Microw. Theory Tech., vol. 36, no. 12, pp. 1752-1757, Dec. 1988.
[29]Y.-S. Lin, P.-Y. Chang, and C.-L. Lin, “ Compact parallel-coupled microstrip diplexers with good stopband rejection” in Proc. Asia-Pacific Microwave Conference., 2009, pp. 2321 – 2624.
[30]S. Hong and K. Chang; “A 10-35 GHz Six-Channel Microstrip Multiplexer for Wide-Band Communication Systems, ” IEEE Trans. Microw. Theory Tech., vol. 54, no. 4, pp. 1370 – 1378, April 2006.
[31]J. S. Hong, M. J. Landcaster, Microstrip Filters for RF/Microwave Applicatio, John Wiley & Sons, Inc., 2001