跳到主要內容

臺灣博碩士論文加值系統

(216.73.217.165) 您好!臺灣時間:2026/05/16 22:48
字體大小: 字級放大   字級縮小   預設字形  
回查詢結果 :::

詳目顯示

我願授權國圖
: 
twitterline
研究生:李承熹
研究生(外文):Chen-hsi Lee
論文名稱:離心扇支撐肋位置對聲音與聲音品質的影響
論文名稱(外文):The impact of Acoustic and Sound Quality caused by location of impeller rib in blower
指導教授:楊旭光楊旭光引用關係
指導教授(外文):S.K.Yang
學位類別:碩士
校院名稱:國立中山大學
系所名稱:機械與機電工程學系研究所
學門:工程學門
學類:機械工程學類
論文種類:學術論文
論文出版年:2010
畢業學年度:98
語文別:中文
論文頁數:109
中文關鍵詞:聲音品質噪音多翼扇扇葉離心扇
外文關鍵詞:noiseblowersound qualityimpeller
相關次數:
  • 被引用被引用:0
  • 點閱點閱:696
  • 評分評分:
  • 下載下載:0
  • 收藏至我的研究室書目清單書目收藏:0
中文摘要
現代科技越來越進步,造就了CPU與硬體的處理速度大幅度提升,相對的工作溫度也增加許多,所以為了不因過高的溫度讓零件壽命縮短,必須要採取主動式散熱才能解決,也就是利用風扇所產生的強迫對流將熱量帶走,但是風扇運轉時所產生噪音,雖然還不至於會損壞聽覺,卻有可能會影響使用者情緒;隨著人們對於電腦越來越依賴,風扇的噪音問題漸漸被注重,因此近幾年在風扇的研發上,除了要增加散熱效率之外,對於噪音要求也越來越高。
本文將研究離心扇為主,以AIO 電腦為實驗系統;AIO電腦是主機與螢幕合而為一的電腦系統,其特點就是內部空間較小、散熱不易,因此一般都會選擇離心扇來作為主要的散熱風扇,但是離心扇的缺點就是噪音較高,所以本文將針對離心扇的噪音做改善研究;以改變支撐肋位置作為實驗的設定,實驗方法分為三個步驟;第一:模擬上下進風口速度分佈的差異、第二:實際量測離心扇,分為單體與入系統的噪音量測與聲音品質的判定、第三:性能測試;研究結果顯示,支撐肋在中間的設計,在噪音方面降低了10%左右,聲音品質的改善也有近50%的成效,性能也有10%左右的提升,因此支撐肋在中間設計,針對雙進風離心扇,為較佳的設計。
Abstract
The advances of modern technology , creating a CPU and
hardware speed greatly enhance the relative increase in number of work- ing temperature , so as not to make parts for high temperature, shortened life expectancy , we must take active cooling can be resolved , is gener-
ated by the use of forced convection fan the heat away , but the fan noise when running , although not damage the hearing , have the potential to affect users of emotions ; as people increasingly rely on the computer, the fan gradually pay attention to the noise problem , so fans of R & D in recent years , in addition to increasing thermal efficiency , the increasing demands for noise.
This article will examine the main centrifugal fan to AIO computer system for the experiment; AIO computer is the host and screen into one of the computer system, characterized by the internal space is small, heat is not easy, so the general would choose as the main centrifugal fan cooling fan, but the disadvantage of centrifugal fan noise is high, so this will do for the improvement of centrifugal fan noise research; to change the location of support ribs as the experimental setting, experimental method consists of three steps; first: Analog and down air inlet differences in velocity distribution, the second: the actual measurement centrifugal fan, is divided into single and measurement noise into the system and the sound quality of the judge, the third: performance testing; study showed that support rib in the middle of the design, the noise about 10% area reduction, sound quality also improved the effectiveness of nearly 50%, performance is also about 10% of the upgrade, the support rib in the middle of the design for double inlet centrifugal fans, for
the better design.
目錄
誌謝.................. I.
中文摘要................ II.
英文摘要................ III.
目錄.................. IV.
表目錄................. VII.
圖目錄................. VIII.
符號說明................ XIII.
第一章 緒論............. 1.
1-1前言................. 1.
1-2研究動機與內容概述.......... 3.
1-3文獻回顧............... 4.
第二章 離心扇的設計............ 6.
2-1離心扇的用途與原理.......... 6.
2-2離心扇的組成............. 7.
2-2-1馬達組成介紹............ 7.
2-2-2扇葉組成介紹............ 8.
2-2-3 軸承系統組成介紹........ . 9.
2-2-4 上蓋與底座介紹 .......... 10.
2-3 風扇選用與設計............ 10.
2-3-1系統總冷卻的需求.......... 10.
2-3-2系統組抗曲線............ 11.
2-3-3 風扇P-Q曲線............ 12.
2-3-4 風扇設計流程........... 13.
第三章 基礎理論與測試規範......... 24.
3-1 聲壓與聲壓值量測 ........... 24.
3-2 聲音品質的介紹............ 26.
3-3 風扇量測方式設定........... 30.
第四章 原始設計問題點與實驗流程...... 36.
4-1 原始設計問題點探討.......... 36.
4-2 實驗流程............... 39.
第五章 模擬分析與模型製作......... 49.
5-1 邊界模擬分析.................. 49.
5-1-1 實驗模型2D/3D設計......... 49.
5-1-2 模擬結果與分析........... 50.
5-2 模型製作............... 52.
5-2-1 軸承組製作............. 52.
5-2-2 扇葉組製作............. 53.
5-2-3 馬達組製作............. 54.
5-2-4 加工設備介紹 ............ 55.
5-3 量測設備介紹............. 56.
5-3-1 噪音量測設備介紹.......... 56.
5-3-2 性能量測設備介紹.......... 58.
第六章 量測結果分析與討論......... 80.
6-1 聲音量測結果與分析.......... 80.
6-2 聲音品質量測結果與分析........ 82.
6-3 性能量測結果與分析.......... 83.
第七章 結論與未來展望........... 92.
參考文獻................. 93.
參考文獻
【1】 CNS 8753,”風扇、鼓風機、壓縮機噪音及測定法”,中國國家標準,CNS 8753,Z8024。
【2】 廖家堃,”離心式鼓風機之流場與噪音研究”,國立清華大學碩士論文,1997。
【3】 呂永泰,”鼓風機渦卷殼之設計暨流場與聲場研究”,國立清華大學碩士論文,1998。
【4】 游昌隆,”橫流式風扇之流場與其引發噪音之研究”,國立清華大學碩士論文,2001。
【5】 何展效、江文旺,1992「風扇噪音振動測試技術」,機械工業雜誌,第三期,第145~178頁。
【6】 王光賢,“葉輪轉子扭轉角之橫流扇聲音品質探討”,國立台北科技大學碩士論文,2004。
【7】 李炫秉,“聲強法在離心扇噪音診斷與控制之研究”,國立台灣科技大學碩士論文,2001。
【8】廖祿甫,”渦殼對離心式泵性能的影響,”國立成功大學航空
太空工程學系碩士論文,1997。
【9】游裕傑, “離心式電腦風扇的設計與分析”,國立成功大學機械工程學系碩士論文,2002。
【10】張裕慶,“軸流風扇之數值模擬,”國立台灣科技大學機械工
程技術研究所碩士 論文,1997。

【11】黃家烈,“筆記型電腦散熱風扇之研究,”國立台灣科技大學機械工程研究所博 士論文,2001。
【12】顧哲安,“筆記型電腦之風扇設計與振動分析,”國立成功大學機械工程研究所 碩士論文,2001。
【13】江易儒,“導管風扇之流場分析,”國立成功大學航空太空工程研究所碩士論 文,1996。

【14】李新立,“工業用離心式風機實驗研究與性能提升探討,”國立清華大學碩士論 文,1998。

【15】孟德化,“軸流式風扇葉片設計,”國立成功大學航空太空工程研究所碩士論 文,1995。
QRCODE
 
 
 
 
 
                                                                                                                                                                                                                                                                                                                                                                                                               
第一頁 上一頁 下一頁 最後一頁 top