跳到主要內容

臺灣博碩士論文加值系統

(216.73.216.41) 您好!臺灣時間:2026/01/13 16:55
字體大小: 字級放大   字級縮小   預設字形  
回查詢結果 :::

詳目顯示

我願授權國圖
: 
twitterline
研究生:蔡晉玄
研究生(外文):Chin-Shuan Tsai
論文名稱:新穎破壞性接地面架構之超寬頻濾波器
論文名稱(外文):Novel Ultra-Wideband Bandpass Filters By Using Defected Ground Structre
指導教授:陳立軒陳立軒引用關係林文寬林文寬引用關係
指導教授(外文):Lih-Shan ChenWen-Kuan Lin
學位類別:碩士
校院名稱:義守大學
系所名稱:電子工程學系碩士班
學門:工程學門
學類:電資工程學類
論文種類:學術論文
論文出版年:2008
畢業學年度:96
語文別:中文
論文頁數:100
中文關鍵詞:破壞性接地面結構啞鈴型互補式隙環共振器多模態超寬頻濾波器
外文關鍵詞:complementary split ring resonatordumb-belldefected ground structuremultimode ultra wideband bandpass filters
相關次數:
  • 被引用被引用:0
  • 點閱點閱:1006
  • 評分評分:
  • 下載下載:0
  • 收藏至我的研究室書目清單書目收藏:0
本論文主要為使用破壞性接地面結構來製作微帶線帶通濾波器,分別利用啞鈴型、互補式隙環共振器來製作寬抑制特性帶通濾波器與微小化超寬頻濾波器。磁耦合槽線、雙開口互補式隙環共振器來改善多模態超寬頻濾波器高頻衰減度與具備寬止帶特性帶拒濾波器。本論文可分為電路設計與實作兩大部份,電路設計部份首先利用破壞性接地面改善濾波器特性或設計為帶通濾波器來決定破壞性接地面設計方式,然後利用全波模擬軟體IE3D模擬頻率響應圖來驗證設計是否可行,並由S參數計算等效電路L-C值,實作方面為利用FR4雙面電路板來製作所設計的濾波器,並利用網路分析儀量測實作元件的特性。
Defected ground structures are adopted to fabricate microstrip bandpass filters in this study. Miniaturized and wide frequency range suppressed ultra wideband bandpass filters are implemented by using dumb-bell and complementary split ring resonators. In addition, magnetic coupling slot lines and double cut complementary split ring resonators are used to improve high frequency attenuation of multi-mode ultra wideband bandpass filters. This thesis contains two parts: design of bandpass filters and their implementations.Different types of defected ground structures are used to improve the performances of the filters or used as resonators. Full wave simulator IE3D is employed to simulate the frequency responses of the designed bandpass filters. The designed filters are fabricated on FR4 substrates and the frequency responses of the implemented filters are measured by the network analyzer.
目錄
中文摘要 I
英文摘要 II
誌謝 III
目錄 IV
圖目錄 VI
表目錄 X
第一章 緒論 1
1-1 研究動機 1
1-2 論文架構 2
第二章 基本理論 4
2-1 微帶線理論 4
2-2 微帶線諧振器種類 10
2-3 濾波器規格 11
第三章 具寬抑制特性DGS帶通濾波器 14
3-1 啞鈴型 DGS基本架構 15
3-2 啞鈴型DGS帶通濾波器 16
3-3啞鈴型帶通濾波器設計流程圖 18
3-4寬抑制特性帶通濾波器 19
3-5設計寬抑制特性帶通濾波器 22
第四章具寬止帶開迴路帶通濾波器 24
4-1開迴路帶通濾波器理論 25
4-2零度饋入基本理論 28
4-3隙環共振器與互補式隙環共振器 29
4-4雙止帶隙環共振器 31
4-5雙開口槽線共振器 33
4-6寬止帶隙環共振器 34
4-7 DU-CSRR設計流程圖 35
4-8具寬止帶開迴路帶通濾波器製作 36
第五章 互補式隙環共振器之超寬頻帶通濾波器 44
5-1互補式隙環共振器高頻補償 46
5-2 CSRR帶通濾波器 47
5-3 CSRR 超寬頻濾波器 48
5-4 CSRR超寬頻實作設計 51
第六章多模態超寬頻濾波器 54
6-1設計多模態超寬頻濾波器 55
6-2多模態共振器頻寬控制 58
6-3 利用矩形DGS改善多模態超寬頻濾波器 61
6-4磁耦合槽線共振器 67
6-4-1不同DGS止帶架構 68
6-4-2 C型槽線共振器 71
6-4-3磁耦合槽線 75
6-5設計寬高頻抑制多模態超寬頻濾波器 77
第七章 結論 84
參考文獻 86
[1] Federal Communications Commission , “Revision of Part 15 of the
Commission’s Rules Regarding Ultra-wideband Transmission
Systems”, First Report and Order, FCC 02.V48, Apr. 2002.
[2] L .A . Trinogga,G . Kaizhou , I . C. Hunter , “Practical Microstrip Circuit Design “ Ellis Horwood , 1991 .
[3] E . O . Hammerstard , “ Proceeding of the Europeam Microwave Conference” , pp.268-272,1975.
[4] E . O . Hammerstard and O . Jensen , ”Accurtae models for microstrip computer-aided design “ IEEE MIT-S, pp . 407-409, 1980.
[5] Ahn, D.; Park, J.-S.; Kim, C.-S.; Kim, J.,Qian, Y.; Itoh, T , “A Design of the Low-Pass Filter Using the Novel Microstrip Defected Ground Structure”
IEEE Transactions ,Microwave Theory and Techniques, volume 49, Page(s):86 – 93,Jan. 2001 .
[6] Abdel-Rahman, A., Verma, A.K., Boutejdar, A., Omar, A.S.”Compact Stub Type Microstrip Bandpass Filter Using Defected Ground Plane” , Page(s):136 – 138, April 2004.
[7] Hung-Wei Wu,Min-Hang Weng,Yan-Kuin Su,Ru-Yuan Yang,Cheng-Yuan Hung” PROPAGATION CHARACTERISTICS OF COMPLEMENTARY SPLIT- RING RESONATOR FOR WIDE BANDGAP ENHANCEMENT IN MICROSTRIP BANDPASS FILTER” Microwave and Optical Technology Letters, v 49, no.2, p 292-295, February 2007.
[8] 翁敏航 , “射頻被動元件設計” , 出版社:東華書局股份有限公司
[9] Chih-Ming Tsai, Sheng-Yuan Lee, Chin-Chuan Tsai , “HAIRPIN FILTERS WITH TUNABLE TRANSMISSION ZEROS”, volume 3, 20-25 Page(s): 2175 - 2178 vol.3, May 2001.
[10] Baena, J.D., Bonache, J., Martin, F., Sillero, R.M., Falcone, F., Lopetegi, T., Laso, M.A.G., Garcia-Garcia, J.,Gil, I.; Portillo, M.F., Sorolla, M. ,“ Equivalent -Circuit Models for Split-Ring Resonators and Complementary Split-Ring Resonators Coupled to Planar Transmission Lines” , IEEE Transactions, Microwave Theory and Techniques, volume 53, Part 2, Page(s):1451 - 1461,April 2005 .
[11] Marques, R., Mesa, F., Martel, J., Medina, F. , “Comparative Analysis of Edge- and Broadside- Coupled Split Ring Resonators for Metamaterial Design - Theory and Experiments” , IEEE Transactions ,Antennas and Propagation, volume 51, Part 1, Page(s):2572 – 2581, Oct. 2003 .


[12] Koray Aydin, Irfan Bulu, Kaan Guven, Maria Kafesaki, Costas M Soukoulis and Ekmel Ozbay , “Investigation of magnetic resonances for different split-ring resonator parameters and designs” , New Journal of Physics 7,168,2005.
[13] Ekmel Ozbay, Koray Aydin, Ertugrul Cubukcu, and Mehmet Bayindir , “ Transmission and Reflection Properties of Composite Double Negative Metamaterials in Free Space” , volume 51, Part 1, Page(s):2592 – 2595,
Oct. 2003.
[14]Composie Right / Left-Handed Transmission Line Metamaterials, IEEE microwave magazine, September 2004
[15] B. SAUVIAC, C. R. SIMOVSKI, S. A. TRETYAKOV,” Double Split-Ring Resonators: Analytical Modeling and Numerical Simulations” Electromagnetics, 24:317–338, 2004 .
[16] Francisco Falcone, Txema Lopetegi, , Juan D. Baena, Ricardo Marqués, Ferran Martín,and Mario Sorolla , “Effective Negative-ε Stopband Microstrip Lines Based on Complementary Split Ring Resonators” , IEEE ,Microwave and Wireless Components Letters, Volume 14, Page(s):280 - 282 ,June 2004.
[17] C Li and Fang Li , “Characterization and modelling of a microstrip line loaded with complementary split-ring resonators (CSRRs) and its application to highpass filters” , 4 June 2007 .
[18] Lei Zhu, Sheng Sun and Wolfgang Menzel , “Ultra-Wideband (UWB) Bandpass Filters Using Multiple-Mode Resonator” , IEEE Microwave and Wireless Components Letters, volume 15, Page(s):796 - 798 ,Nov. 2005.
[19] Guo-Min Yang, , R. Jin, C. Vittoria, , V. G. Harris, , and N. X. Sun , “Small Ultra-Wideband (UWB) Bandpass Filter With Notched Band” , IEEE Microwave and Wireless Components Letters, Volume 18, Page(s):176 - 178 ,March 2008.
[20] Yang, G.M.; Jin, R.H.; Geng, J.P. , “Planar microstrip UWB bandpass filter using U-shaped slot coupling structure” volume 42, Page(s):1461 – 1463 ,December 2006.
[21] Lei Zhu; Huizheng Bu; Ke Wu , “APERTURE COMPENSATION TECHNIQUE FOR INNOVATIVE DESIGN OF ULTRA -BROADBAND MICROSTRIP BANDPASS FILTER” 2000 IEEE MTT-S International Microwave Symposium Digest, vol.1 ,Page(s):315 - 318, June 2000.
[22] Garcia-Garcia, J.; Bonache, J.; Martin, F. , “Application of Electromagnetic Bandgaps to the Design of Ultra-Wide Bandpass Filters With Good Out-of-Band Performance” , IEEE Transactions, Microwave Theory and Techniques, Volume 54, Part 1, Page(s):4136 – 4140, Dec. 2006.
[23] Yang, G.M.; Jin, R.; Geng, J.; Huang, X.; Xiao, G , “Ultra-wideband bandpass filter with hybrid quasi-lumped elements and defected ground structure “ , Microwaves, Antennas & Propagation, IET volume 1, Page(s):733 - 736 , June 2007.
[24] Zhang, R.; Mansour, R.R. , “A Novel Lowpass Microstrip Filter Using Metal-Loaded Slots in the Ground Plane” , 2004 IEEE MTT-S International
,Microwave Symposium Digest, Vol.3 , Page(s):1311 – 1314, June 2004 .
[25] Duk-Jae Woo; Taek-Kyung Lee; Jae-Wook Lee; Cheol-Sig Pyo; Won-Kyu Choi , “Novel U-Slot and V-Slot DGSs for Bandstop Filter With Improved Q Factor” , Volume 54, Part 2, Page(s):2840 - 2847 ,June 2006.
QRCODE
 
 
 
 
 
                                                                                                                                                                                                                                                                                                                                                                                                               
第一頁 上一頁 下一頁 最後一頁 top