跳到主要內容

臺灣博碩士論文加值系統

(3.235.56.11) 您好!臺灣時間:2021/07/29 03:46
字體大小: 字級放大   字級縮小   預設字形  
回查詢結果 :::

詳目顯示

: 
twitterline
研究生:林元致
研究生(外文):Lin, Yuan-Chih
論文名稱:微電力風力發電機之研製
論文名稱(外文):Wind-Mill Micro-Power Generator
指導教授:林瑞昇吳朗
指導教授(外文):Lin, Jui-ShengWu, Long
口試委員:吳孟軍陳永欽李茂順邱明誠
口試委員(外文):Wu, Menq-JionChen, Yong-chinLee, Maw-ShungChure, Ming-Cherng
口試日期:2012-07-12
學位類別:碩士
校院名稱:遠東科技大學
系所名稱:電機工程研究所
學門:工程學門
學類:電資工程學類
論文種類:學術論文
論文出版年:2012
畢業學年度:100
語文別:中文
論文頁數:72
中文關鍵詞:壓電陶瓷發電特性陶瓷片結構
外文關鍵詞:piezoelectric ceramicspower generation characteristicsceramics Structure
相關次數:
  • 被引用被引用:0
  • 點閱點閱:160
  • 評分評分:
  • 下載下載:22
  • 收藏至我的研究室書目清單書目收藏:0
發展綠色電能以減緩全球暖化現象目前已經成為全球之發展趨勢。大型市電並聯型風力發電系統為現今最具經濟效益的綠色電能來源,而獨立型小型風力發電系統之應用亦日益增加。由於獨立型小型風力發電系統需有充電機將風能儲存於電池中,良好的充電控制方法有助於更有效的利用風能。
本論文將提出適用於小型微電力風力發電系統之創新研究,此方法擺脫以往小型風力發電機侷限於某些應用上。本論文所提之發電方式雖比傳統小型風力發電機之發電量小,但較輕巧方便,非專業人員就能夠輕易組合上去。
由實驗結果可以發現到無論那一種結構及材質,陶瓷片的開路電壓、經整流的輸出電壓及輸出電流均隨著轉速增加而上升。對瘦長型A結構而言,當轉速為3423rpm時,可產生1.5746V之開路電壓及0.52μA之輸出電流,而對胖寬型而言,在相同的轉速時,其輸出電壓及輸出電流分別為0.7708V及0.42μA。串聯結構的開路電壓、經整流的輸出電壓及輸出電流較並聯結構為高。

In order to slow global warming development of green energy has become a global development trends. Large-scale grid connected wind power generation system for today's is the most cost-effective green energy sources. Besides, the application of independent small-scale wind power generation system is also increasing. Independent small-scale wind power generation system needs to have a battery charger; wind energy is stored in the battery. So, the control methods at the better change can contribute to more effective use of wind energy.
This paper will study the innovative research for small micro-power wind power generation system, this method to get rid of small wind turbines in the past limited to certain applications. From the experimemtal results, the proposed power generation than the traditional small-scale wind turbine power generation, a small amount, but more compact and convenient, non-professionals can easily combine up.
From the experimental results can be found no matter what kind of structure and material, ceramic open-circuit voltage, the rectified output voltage and output current as the speed increases and rising.Elongated type A structure, when the speed is 3423rpm, can produce the 1.5746V open circuit voltage and to 0.52μA the output current of fat wide type, then the same speed, the output voltage and output current respectively.0.7708V and 0.42μA. The open circuit voltage of the tandem structure, the rectifier output voltage and output current is higher than the parallel structure.

總目錄
摘要 I
Abstract II
誌謝 IV
總目錄 V
圖目錄 VII
表目錄 XI
第一章 概論 1
1.1 研究動機及目的 1
1.2 文獻回顧 5
1.3 本文架構 13
第二章 壓電理論及壓電發電應用 14
2.1 壓電效應 14
2.2 壓電材料 15
2.3 壓電發電原理與應用 19
2.4 壓電方程式 20
2.5 極化處理 23
2.6 等效電路 24
第三章 實驗方法及流程 28
3.1  陶瓷片基本特性 28
3.2 機台架構與設計 32
3.3 量測方法 38
第四章 結果與討論 43
4.1 瘦長型雙陶瓷片 43
4.2 胖寬型雙陶瓷片 51
4.3 瘦長型雙陶瓷片與胖寬型雙陶瓷片比較 58
第五章 結論與未來展望 67
5.1 結論 67
5.2 未來展望 67
參考文獻 69

[1] E.O. Torres and G.A. Rincon-Mora, “Long-Lasting, Self-Sustaining, and Energy-Harvesting System-in-Package (SIP) Wireless Micro-Sensor Solution" International Conference on Energy, Environment and Disasters (INCEED 2005), Charlotte, North Carolina, USA, 2005.
[2] J. Kymissis, C. Kendall, J. Paradiso and N. Gershenfeld, “Parasitic Power Harvesting in Shoes”, the Second IEEE International Conference on Wearable Computing, 1998.
[3] G.W. Taylor, J.R. Burns and S.M. Kammann, W. B. Powers, and T. R. Welsh, “The Energy Harvesting Eel: A Small Subsurface Ocean/River Power Generator”, IEEE Journal of Oceanic Engineering, Vol.26, No.4, p.69, 2001.
[4] S. Priya, C.T. Chen, D. Fye and J. Zahnd, “Piezoelectric Windmill: A Novel Solution to Remote Sensing,” Japanese Journal of Applied Physics, Vol.44, No.3, pp.104-107, 2005.
[5] S. Roundy, E.S. Leland, J. Baker, E. Carleton, E. Reilly, E. Lai, B. Otis, J.M. Rabaey and P.K. Wright, “Improving Power Output for Vibration-Based Energy Scavengers”, IEEE Pervasive Computing, Vol.4, No.1, pp.28-36, 2005.
[6] T. Roundy, “Human-powered wearable computing,” IBM Systems Journal, Vol.35, pp.618, 1996.
[7] Y. Ammar and S. Basrour, “Non-linear Techniques for Increasing Harvesting Energy from Piezoelectric and Electromagnetic Micro Power Generators”, DTIP of MEMS & MOEMS Stresa, Italy, 26-28 April, 2006.
[8] E. Leffuvre, A. Badel, C. Richard, L. Petit and D. Guyomar, “Optimization of Piezoelectric Electrical Generators Powered by Random Vibrations”, DTIP of MEMS & MOEMS Stresa, Italy, 26-28 April, 2006.
[9] A. Wickenheiser, “Energy Harvesting from Ambient Vibrations using Cantilevered Piezoelectric Transducers”, Dynamics, System and Control Seminar Series, Feb. 27, 2009.
[10] J. A. Paradiso and T. Starner, “Energy Scavenging for Mobile and Wireless Electronics”, PERVASIVE computing, January–March, pp.18-27, 2005.
[11] M.A. Galhardi, T.H. Guilherme and V. Lopes Jr., “A Review of Power Harvesting on Mechanical Vibration using Piezoelectric Materials and Applications”, 7th Braz. Conf. on Dyna. Contr. and Appl., May 7-9, 2008, FCT-Unesp at Presidente Prudente, SP, Brazil, (DINCON’ 2008).
[12] C.N. Xu, M. Akiyama, K. Nonaka, and T. Watanabe, “Electrical Power Generation Characteristics of PZT Piezoelectric Ceramics”, IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, Vol.45, No.4, pp.1065-1070, 1998.
[13] “Piezoelectric ceramics: Principles and Applications”, APC International Ltd., Pennsylvania, USA.
[14] J.H. Cho, M.J. Anderson, R.F. Richards, D.F. Bahr and C.D. Richards, “Analysis of Micromachined PZT Membranes for MEMS Power”, Nanotech, Vol.1, pp.382-385, 2004.
[15] M. Umeda, K. Nakamura and S. Ueha, “Analysis of the Transformation of Mechanical Impact Energy to Electrical Energy using a Piezoelectric Vibrator”, Japanese Journal of Applied Physics, Vol.35, No.5B, Part 1, pp. 3267-3273, 1996.
[16] Y.C. Shu and I.C. Lien, 2006, “Analysis of Power Output for Piezoelectric Energy Harvesting Systems”, Smart Material Structure., Vol.15, pp.1499–1512, 2006.
[17] M.J. Guan and W.H. Liao, “On the Efficiencies of Piezoelectric Energy Harvesting Circuits Towards Storage Device Voltages”, Smart Material Structure, 16, pp.498–505, 2007.
[18] G.Poulin, E.Sarraute and F.Costa, 2004, “Generation of Electric Energy for Portable Device: Comparative Study of An Electromagnetic and A Piezoelectric System”, Sensors Actuators A, Vol.116, pp.461-471, 2004.
[19] 廖偉翔, “壓電換能器於低頻發電應用之設計與分析”, 國立成功大學機械工程學系碩士論文, 2007
[20] 中華太陽能聯誼會--垂直軸風力
http://www.solar-i.com/jwv-4.jpg
[21] 中華太陽能聯誼會--光電少年
http://www.solar-i.com/sj1-5-a.html
[22] 宇宏企業股份有限公司 http://www.radiotek.com.tw/download/fluke/287.pdf
[23] 蒲福風級http://content.edu.tw/senior/earth/tp_ml/wind/windgrad.htm
[24] http://www.sunnytec.com.tw/
[25] http://www.aurelienr.com/electronique/piezo/piezo.pdf
[26] http://shan-shin.webdiy.com.tw/image/cache/data/P/2-500x500.png

QRCODE
 
 
 
 
 
                                                                                                                                                                                                                                                                                                                                                                                                               
第一頁 上一頁 下一頁 最後一頁 top