(3.238.130.97) 您好!臺灣時間:2021/05/15 13:45
字體大小: 字級放大   字級縮小   預設字形  
回查詢結果

詳目顯示:::

我願授權國圖
: 
twitterline
研究生:陳苡謙
研究生(外文):Yi-Chien Chen
論文名稱:以多層蘑菇型架構達成應用於差動傳輸線上之寬頻共模抑制濾波器 設計
論文名稱(外文):A Broadband Filter Design for Common-Mode Noise Suppression with Multilayer Mushroom Structure in Differential Transmission Line
指導教授:林丁丙林丁丙引用關係
指導教授(外文):Ding-Bing Lin
口試委員:鄭瑞清丘建青黃建彰
口試日期:2016-07-09
學位類別:碩士
校院名稱:國立臺北科技大學
系所名稱:電子工程系研究所
學門:工程學門
學類:電資工程學類
論文種類:學術論文
畢業學年度:104
語文別:中文
中文關鍵詞:共模濾波器、多層印刷電路板(Multi-layer Printed Circuit BoardPCB)、 訊號完整性(Signal IntegritySI)。
外文關鍵詞:Common-mode filterMulti-layer Printed Circuit BoardSignal Integrity
相關次數:
  • 被引用被引用:0
  • 點閱點閱:107
  • 評分評分:
  • 下載下載:0
  • 收藏至我的研究室書目清單書目收藏:0
本論文提出一應用在差動傳輸線上的新型寬頻共模抑制濾波器架構,此濾波器利用多層印刷電路板的疊構特性,在蜿蜒差動訊號線下方置入兩個大小不等的多層蘑菇型架構,使其相互作用產生一特定頻帶抑制效果並與其自身高階模態互
相耦合。此種技術可以成功的在所關注的頻率範圍中產生多個相近的傳輸零點以達成寬頻抑制效果。模擬與實作結果證實了此寬頻共模抑制濾波器的技術與特性,頻域上,此寬頻共模抑制濾波器抑制範圍可將共模雜訊從 3.51 GHz 至 13.51 GHz皆抑制於 10 dB 之下,高達 117 %的比例頻寬,其中濾波器的電氣尺寸只有 0.25 λ
A new multi-layer mushroom structure to uppress common-mode noise rejection in differential transmission line is proposed in this thesis. It consists of a pair of differential transmission lines above the proposed multi-layer mushroom-like structures. In other to produce a particular suppression band to couple with the higher order mode, the two mushroom-like structures interacted with each other greatly. This technique can successfully generate many close transmission zeros in common-mode within the concern frequencies. In addition, the simulation and measurement results are verified that the proposed filter prototype can efficiently suppress the common mode noise to -10 dB from 3.51 to 13.55 GHz with 117 % fractional bandwidth (FBW) while the
electrical size of the prototype is 0.25 × 0.25
摘要......ii
ABSTRACT......iii
誌謝......iv
圖目錄......vii
表目錄......x
第一章 緒論......1
1.1 研究動機與目的......1
1.2 文獻探討......4
1.3 論文架構......9
第二章 共模抑制濾波器設計基礎理論......10
2.1 差動訊號傳輸簡介......10
2.2 耦合傳輸線(Coupled Transmission Line)......12
2.3 奇模(Odd-Mode)與偶模(Even-Mode)傳輸分析......13
2.3.1 耦合微帶傳輸線原理......13
2.3.2 奇模傳輸之特性分析......14
2.3.3 偶模傳輸之特性分析......15
2.4 差動電路特性分析與量測......18
2.4.1 混合模態散射參數(Mixed-Mode S-parameter)......18
第三章 應用於多層電路板上之寬頻共模抑制濾波器設計......23
3.1 概述......23
3.1.1 耦合傳輸線阻抗設計......24
3.1.2 單一蘑菇型架構......26
3.2 應用於多層電路板上之寬頻共模抑制濾波器設計與分析......28
3.2.1 單一蘑菇型架構之共模抑制濾波器分析......28
3.2.2 多重蘑菇型架構之共模抑制濾波器分析......33
3.2.3 蜿蜒訊號線之寬頻共模抑制濾波器分析......36
3.2.4 所提出之應用於多層電路板上寬頻共模抑制濾波器設計暨參數分析......39
第四章 模擬與實測結果討論......46
4.1 在頻域中特性分析......46
4.2 在時域中特性分析......51
4.2.1 眼圖量測之差模訊號完整性......51
第五章 結論......54
參考文獻......55
[1] E. Bogatin, Signal Integrity – Simplified, N.J.: Pretice Hall, 2004.
[2] http://en.wikipedia.org/wiki/Differential_signaling
[3] D. G. Kam, H. Lee, J. Kim, J. Kim, “A new twisted differential line structure on
high-speed printed circuit boards to enhance immunity to crosstalk and external
noise,” IEEE Letters, Microwave and Wireless Components, vol 13, pp. 411-413,
Sept. 2003.
[4] Z. Chen, G. Katopis, “A comparison of performance potentials of single ended
vs. differential signaling,” in Proc. 13th, Electrical Performance of Electronic
Packaging Conf., 2004, pp.185-188.
[5] P. E. Fornberg, M. Kanda, P. M. Melinda, and H. H. Stephen, “The impact of a
nonideal return path on differential signal integrity,” IEEE Trans. Electromagn.
Compat., vol. 44, pp. 671-676, Feb. 2002.
[6] N. Orhanovic, R. Raghuram, N. Matsui, “Signal propagation and radiation of
single and differential microstrip traces over split image planes,” in Proc.
International symposium on Electromagnetic compatibility, pp. 339-343, vol.1,
2000.
[7] B. Archambeault, S. Connor, and J. Diepenbrock, “EMI emissions from mismatch
in high-speed differential signal trace and cables,” in Proc. IEEE Int. Symp. Trans.
Electromagn. Compat., Hawaii, July 2007, pp. 1-6.
[8] C.R. Paul, Introduction to Electromagnetic Compatibility, New York: Wiley,
1992.
[9] D. Ahn, J. S. Park, C. S. Kim, J. Kim et al., “A design of the low-pass filter using
the novel microstrip defected ground structure,” IEEE Trans. Microw. Theory
Tech., vol. 49, no. 1, pp. 86–93, Jan. 2001.
[10] A. B. A. Rahman, A. K. Verma, A. Boutejdar, and A. S. Omar, “Control of
bandstop response of Hi-Lo microstrip low-pass filter using slot in ground plane,”
IEEE Trans. Microwave Theory Tech., vol. 52, pp. 1008-1013, March. 2004.
56
[11] J. S. Park, J. H. Kim, J. H. Lee et al., “A novel equivalent circuit and modeling
method for defected ground structure and its application to optimization of a DGS
lowpass filter,” in IEEE MTT-S Int. Dig., 2002, pp. 417-420.
[12] J.-S. Lim, C.-S. Kim, D. Ahn et al., “Design of the low-pass filters using defected
ground structure,” IEEE Trans. Microw. Theory Tech., vol. 53, no. 8, pp.
2539-2545, Aug. 2005.
[13] H. J. Chen, T. H. Huang, C. S. Chang et al., “A novel cross-shape DGS applied to
design ultra-wide stop-band low-pass filters,” IEEE Microwave and Wireless
Components Letters, vol. 16, pp. 252-254, 2006.
[14] L. H. Weng, Y. C. Guo, X. W. Shi et al., “An overview on defected ground
structure,” Progress in Electromagnetics Research B, vol. 7, pp. 173-189, 2008.
[15] Ashwini K. Arya, M. V. Kartikeyan, and A. Patnaik, “Defected Ground Structure
in the perspective of Microstrip antenna,” Frequenz, vol.64, Issue5-6, pp.79-84 ,
Oct. 2010.
[16] D. Jain , “Comparative study of a micro-strip line with DGS and without DGS,”
International Journal of Scientific Engineering and Technology., vol. 1, no. 3, pp.
132-136, July 2012.
[17] C.-H. Tsai and T.-L. Wu, “A broadband and miniaturized common-mode filter
for gigahertz differential signals based on negative permittivity metamaterials,”
IEEE Trans. Microw. Theory Tech., vol. 58, no. 1, pp. 195–202, Jan. 2010.
[18] C. H. Tsai and T. L. Wu, “A metamaterial-typed differential transmission line with
broadband common-mode suppression,” in Proc. IEEE Int. Electromagn. Compat.
Workshop, Athens, Greece, Aug. 2009, pp. 1–4.
[19] C. H. Tsai and T. L. Wu, “A GHz common-mode filter using negative permittivity
metamaterial on low temperature co-fire ceramic (LTCC) substrate,” in Proc. IEEE
Int. Electromagn. Compat. Symp., Austin, TX, Aug. 2009, pp. 91–94.
[20] T. K. Wang, C. Y. Hsieh, H. H. Chuang, and T. L. Wu, “Design and modeling of a
stopband-enhanced EBG structure using ground surface perturbation lattice for
power/ground noise suppression,” IEEE Trans. Microw. Theory Tech., vol. 57, no.
8, pp. 2047–2054, Aug. 2009.
[21] J. Li, J. Mao, and M. Tang, “Mushroom-type ground plane structure for wideband
SSN suppression in high-speed circuits,” IEEE. Microw. Wireless Compon. Lett.,
vol. 21, no. 12, pp. 646–648, Dec. 2011.
57
[22] M. S. Zhang, J. F. Mao, and Y. Liang, “Power noise suppression using power-and
-ground via pairs in multilayered printed circuit boards,” IEEE Trans. Compon.
Packag. Manuf. Technol., vol. 1, no. 3, pp. 374–385, Mar. 2011.
[23] Myunghoi Kim and Dong Gun Kam, "Wideband and Compact EBG Structure with
Balanced Slots," IEEE Trans. Comp. Package Manufact. Technology, vol. 5, no. 6,
pp. 818–827, June 2015.
[24] S. H. Hall, G. W. Hall, and J. A. McCall, High-Speed Digital System Design, A
Handbook of Interconnect Theory and Design Practices, Hoboken, NJ: Wiley,
2000.
[25] S. B. Cohn, “Slotline on a dielectric substrate,” IEEE Trans. Microw. Theory Tech.,
vol. 17, no. 10, pp. 768-778, Oct. 1969.
[26] D. E. Bockelman and W. R. Eisenstadt, “Combined differential and common-mode
scattering parameters: Theory and simulation,” IEEE Trans. Microwave Theory
Tech., vol. 43, pp.1530-1539, July 1995.
[27] W. Fan, A. C. Lu, L. L. Wai and B. K. Lok, “Mixed-Mode S-parameter
Characterization of Differential Structures,” in Proc. IEEE 5th Electronics
Packaging Technology Conf., pp. 533 – 537, Dec. 2003.
[28] Y. Chen and S. Yang, “Mixed mode S-parameters analysis for differential networks
in integrated circuits, ” in Proc. the 16th IPFA IEEE Int. Symp., pp. 268-273, July
2009.
[29] 祁子年,使用雙埠網路分析儀量測四埠與差動元件之研究,碩士論文,國立
中央大學,桃園,2008。
[30] J. S. Hong, and M. J. Lancaster, Microstrip Filters for RF/Microwave Application,
John Wiley & Sons, Inc., 2001.
[31] Ansoft HFSS user’s Guide—High Frequency Structure Simulator, Ansoft Co.,
2003.
[32] C. Y. Hsiao, C. H. Tsai, C. N. Chiu, and T. L. Wu, “Radiation suppression for
cable-attached packages utilizing a compact embedded common-mode filter,”
IEEE Trans. Compon., Packag., Manuf. Technol., vol. 2, no. 10, pp. 1696–1703,
Oct. 2012.
電子全文 電子全文(網際網路公開日期:20210718)
連結至畢業學校之論文網頁點我開啟連結
註: 此連結為研究生畢業學校所提供,不一定有電子全文可供下載,若連結有誤,請點選上方之〝勘誤回報〞功能,我們會盡快修正,謝謝!
QRCODE
 
 
 
 
 
                                                                                                                                                                                                                                                                                                                                                                                                               
第一頁 上一頁 下一頁 最後一頁 top